Quantum Scalar 50 Quick Start Manual page 21

Figure 16 Scalar 50 Cable
Configuration (SCSI Full Height
Drives)
Figure 17 Scalar 50 Cable
Configuration (Native Fibre
Channel Full Height Drives)
Caution: The SCSI cables used to connect to the library system controller board
MUST have an offset connector. Using a straight-in SCSI connector
may damage the system controller board.
Ethernet SCSI host
Power
Ethernet Fibre Channel host/SAN
Power
LTO Tape drives
shown. SDLT drives
have a single FC port
SCSI System Controller Board
Tape drive 2
FC System Controller Board
Tape drive 2
Fibre Channel
host/SAN
Installing the Library
Scalar 50 Tape Library
Tape drive 1
Back of Library
Back of Library
Tape drive 1
Fibre Channel
host/SAN
21