Figure 37 Removing the
FlexLink Cover
Remove only the
bottom FlexLink
cover on the top
library in the stack
2 The alignment hardware installed on the top and bottom of the libraries in a multiple
stack allow the FlexLink bays to align correctly when installed in a rack. Install the
following alignment hardware (see
a
Install the top alignment hardware with two Allen head screws.
b
Install the bottom alignment hardware with one Allen head screw.
Note:
Install only the bottom alignment hardware on the top library in the stack
and the top alignment hardware on the bottom library in the stack.
Multiple Library Stacks
Scalar 50 Tape Library
figure
38):
Remove only the top
FlexLink cover on the
bottom library in the
stack
Screws
FlexLink cover
FlexLink cover
Screws
37