Quantum Scalar 50 Quick Start Manual page 30

Scalar 50 Quick Start Guide
Figure 27 Date and Time
Screen
Figure 28 Network Screen
30
The Date and Time screen displays the following information about the library:
2 Use the up and down arrows to view or edit the time zone, date, and time
information. Press
Enter
3 When you are finished viewing/editing the date and time information, press Exit to
return to the Setup screen.
Setting Network Information
To view or edit the network information:
Note: If you are using DHCP, you do not have to setup the following network
information. Once the library is on-line, it is ready to use.
The library must be offline to change these settings.
Note:
1 From the Setup screen, use the up and down arrows to highlight Network and press
Enter.
The Network screen displays (see
The Network screen allows you to view or edit the following network settings:
• DHCP (default setting)
• IP address
• Subnet mask
• Default gateway
2 Use the up and down arrows to select the network setting you wish to view or edit
and press .
Enter
When you are finished viewing/editing the network information, press Back, then
to return to the Setup screen.
Exit
Installing the Library
to accept the new settings.
figure 28):
0