Quantum Scalar 50 Quick Start Manual page 34

Scalar 50 Quick Start Guide
Figure 33 Setup Wizard
(Configure Devices)
Figure 34 Setup Wizard
(Configuring Load Ports)
34
9 Set the SCSI ID for the SCSI devices in the library.
Note: SAS tape drives do not require a SCSI ID. Use the default configuration for
SAS tape drives.
10 Click to continue.
Next
The
Setup Wizard (Configuring Load Ports)
11 Enable or disable the load ports for this library.
12 Click to continue.
Next
The
Setup Wizard (Configuring Partitions)
page displays (see
page displays (see
Setup Wizard
figure 34).
figure 35).