Quantum Scalar 50 Quick Start Manual page 41

Testing a Multiple Library
Stack Configuration
Figure 42 Move Page
7 Select the new library cabinet from the cabinet drop down list.
8 Click the
Start Test
The system performs a health test on all robotic axis. The test results can be viewed at
the bottom of the page. If any failures occur, contact Quantum.
If this is a multiple library stack configuration, you must verify the tape cartridge pass
0
through capability to ensure normal library operation.
The following procedure requires at least one tape cartridge in the bottom most
Note:
library in the library stack.
To test a multiple library stack configuration:
1 To access the
Move
the page.
The page displays (see
Move
Move cartridge
Source
Destination
2 To move a cartridge:
In the
a
Source Partition
b In the
Source Element
c In the
Source Position
d In the
Destination Partition
e In the
Destination Element
f In the
Destination Position
Testing the Library Configuration
button.
page, from the
Operations
figure 42):
, select the bottom most cabinet in the library stack.
, select a slot.
, select a slot number containing a tape cartridge.
, select the top most cabinet in the library stack.
, select a slot.
, select an empty slot number.
Scalar 50 Tape Library
page, click on the tab at the top of
Move
41