Cable The Device - Cisco FPR1010-ASA-K9 Getting Started Manual

ASA Deployment with ASDM
!
dhcpd auto_config outside
dhcpd address 192.168.1.20-192.168.1.254 inside
dhcpd address 192.168.45.10-192.168.45.12 management
dhcpd enable inside
dhcpd enable management
!
http server enable
http 192.168.45.0 255.255.255.0 management
http 192.168.1.0 255.255.255.0 inside
!
dns domain-lookup outside
dns server-group DefaultDNS
name-server 208.67.222.222 outside
name-server 208.67.220.220 outside
!

Cable the Device

Manage the Firepower 1010 on either Management 1/1, or on Ethernet 1/2 through 1/8 (inside switch ports).
The default configuration also configures Ethernet 1/1 as outside.
Procedure
Step 1 Install and familiarize yourself with your hardware using the
Step 2 Connect your management computer to one of the following interfaces:
• Ethernet 1/2 through 1/8—Connect your management computer directly to one of the inside switch ports
(Ethernet 1/2 through 1/8). The inside interface has a default IP address (192.168.1.1) and also runs a
DHCP server to provide IP addresses to clients (including the management computer), so make sure
these settings do not conflict with any existing inside network settings (see
Configuration, on page 173).
hardware installation guide.
Firepower 1010 Default
Cisco Firepower 1010 Getting Started Guide
Cable the Device
175