Cisco FPR1010-ASA-K9 Getting Started Manual page 132

Cable the Firewall
Your network administrator needs your firewall serial number to facilitate low-touch provisioning, connect
to the firewall, and configure it remotely.
Communicate with the CDO administrator to develop an onboarding timeline.
Cable the Firewall
This topic describes how to connect the Firepower 1010 to your network so that it can be managed by CDO.
If you received a firewall at your branch office, and your job is to plug it in to your network,
The video describes your firewall and the LED sequences on the firewall that indicate the firewall's status. If
you need to, you'll be able to confirm the firewall's status with your IT department just by looking at the LEDs.
Figure 42: Cabling the Firepower 1010
Low-touch provisioning supports connecting to CDO on Ethernet 1/1 (outside).
Note
Procedure
Step 1 Install the chassis. See the
Cisco Firepower 1010 Getting Started Guide
130
Ethernet1/2 through 1/8 are configured as hardware switch ports; PoE+ is also available on Ethernet1/7
and 1/8.
hardware installation
Threat Defense Deployment with CDO
guide.
watch this video.