Cisco FPR1010-ASA-K9 Getting Started Manual page 111

Threat Defense Deployment with the Device Manager
You can also fine-tune the WINS and DNS list supplied to clients on the Configuration tab. The following
example shows how to set up a DHCP server on the inside2 interface with the address pool
192.168.4.50-192.168.4.240.
Figure 32: DHCP Server
Step 4 Choose Device, then click View Configuration (or Create First Static Route) in the Routing group and
configure a default route.
The default route normally points to the upstream or ISP router that resides off the outside interface. A default
IPv4 route is for any-ipv4 (0.0.0.0/0), whereas a default IPv6 route is for any-ipv6 (::0/0). Create routes for
each IP version you use. If you use DHCP to obtain an address for the outside interface, you might already
have the default routes that you need.
Note
The following example shows a default route for IPv4. In this example, isp-gateway is a network object that
identifies the IP address of the ISP gateway (you must obtain the address from your ISP). You can create this
object by clicking Create New Network at the bottom of the Gateway drop-down list.
The routes you define on this page are for the data interfaces only. They do not impact the
management interface. Set the management gateway on Device > System Settings > Management
Interface.
Configure the Firewall in the Device Manager
Cisco Firepower 1010 Getting Started Guide
109