Cisco FPR1010-ASA-K9 Getting Started Manual page 114

Access the Threat Defense and FXOS CLI
Procedure
Step 1
To log into the CLI, connect your management computer to the console port. The Firepower 1000 ships with
a USB A-to-B serial cable. Be sure to install any necessary USB serial drivers for your operating system (see
the Firepower 1010
settings:
• 9600 baud
• 8 data bits
• No parity
• 1 stop bit
You connect to the FXOS CLI. Log in to the CLI using the admin username and the password you set at
initial setup (the default is Admin123).
Example:
firepower login: admin
Password:
Last login: Thu May 16 14:01:03 UTC 2019 on ttyS0
Successful login attempts for user 'admin' : 1
firepower#
Step 2 Access the threat defense CLI.
connect ftd
Example:
firepower# connect ftd
>
After logging in, for information on the commands available in the CLI, enter help or ?. For usage information,
see Cisco Secure Firewall Threat Defense Command
Step 3
To exit the threat defense CLI, enter the exit or logout command.
This command returns you to the FXOS CLI prompt. For information on the commands available in the FXOS
CLI, enter ?.
Example:
> exit
firepower#
Cisco Firepower 1010 Getting Started Guide
112
hardware guide). The console port defaults to the FXOS CLI. Use the following serial
Threat Defense Deployment with the Device Manager
Reference.