Cisco FPR1010-ASA-K9 Getting Started Manual page 22

Complete the Threat Defense Initial Configuration Using the CLI
Figure 6: Successful Connection
Complete the Threat Defense Initial Configuration Using the CLI
Connect to the threat defense CLI to perform initial setup, including setting the Management IP address,
gateway, and other basic networking settings using the setup wizard. The dedicated Management interface is
a special interface with its own network settings. In 6.7 and later: If you do not want to use the Management
interface for the manager access, you can use the CLI to configure a data interface instead. You will also
configure the management center communication settings. When you perform initial setup using the device
manager (7.1 and later), all interface configuration completed in the device manager is retained when you
switch to the management center for management, in addition to the Management interface and manager
access interface settings. Note that other default configuration settings, such as the access control policy, are
not retained.
Procedure
Step 1 Connect to the threat defense CLI, either from the console port or using SSH to the Management interface,
which obtains an IP address from a DHCP server by default. If you intend to change the network settings, we
recommend using the console port so you do not get disconnected.
The console port connects to the FXOS CLI. The SSH session connects directly to the threat defense CLI.
Step 2
Log in with the username admin and the password Admin123.
At the console port, you connect to the FXOS CLI. The first time you log in to FXOS, you are prompted to
change the password. This password is also used for the threat defense login for SSH.
Note
Example:
Cisco Firepower 1010 Getting Started Guide
20
If the password was already changed, and you do not know it, you must reimage the device to reset
the password to the default. See the
Threat Defense Deployment with the Management Center
FXOS troubleshooting guide for the reimage procedure.