What's Next - Cisco FPR1010-ASA-K9 Getting Started Manual

Threat Defense Deployment with the Management Center
Step 7
You can now unplug the power to physically remove power from the chassis if necessary.
Power Off the Device at the CLI
You can use the FXOS CLI to safely shut down the system and power off the device. You access the CLI by
connecting to the console port; see
Procedure
Step 1
In the FXOS CLI, connect to local-mgmt:
firepower # connect local-mgmt
Step 2 Issue the shutdown command:
firepower(local-mgmt) # shutdown
Example:
firepower(local-mgmt)# shutdown
This command will shutdown the system.
Please enter 'YES' or 'NO': yes
INIT: Stopping Cisco Threat Defense......ok
Step 3 Monitor the system prompts as the firewall shuts down. You will see the following prompt:
System is stopped.
It is safe to power off now.
Do you want to reboot instead? [y/N]
Step 4 You can now unplug the power to physically remove power from the chassis if necessary.

What's Next?

To continue configuring your threat defense, see the documents available for your software version at
the Cisco Firepower
For information related to using the management center, see the
Guide.
Access the Threat Defense and FXOS CLI, on page
Continue?
Documentation.
Power Off the Device at the CLI
Firepower Management Center Configuration
Cisco Firepower 1010 Getting Started Guide
43.
Navigating
45