Cisco FPR1010-ASA-K9 Getting Started Manual page 138

Perform Initial Configuration
Step 8
For the CLI Registration Key, CDO generates a command with the registration key and other parameters.
You must copy this command and use it in the intial configuration of the threat defense.
configure manager add cdo_hostname registration_key nat_id display_name
Complete initial configuration at the CLI or using the device manager:
•
•
Example:
Sample command for CLI setup:
configure manager add account1.app.us.cdo.cisco.com KPOOP0rgWzaHrnj1V5ha2q5Rf8pKFX9E
Lzm1HOynhVUWhXYWz2swmkj2ZWsN3Lb account1.app.us.cdo.cisco.com
Sample command components for GUI setup:
Figure 46: configure manager add command components
Step 9 Click Next in the onboarding wizard to start registering the device.
Step 10 (Optional) Add labels to your device to help sort and filter the Inventory page. Enter a label and select the
blue plus button (
What to do next
From the Inventory page, select the device you just onboarded and select any of the option listed under the
Management pane located to the right.
Perform Initial Configuration
Perfom initial configuration of the threat defense using the CLI or using the device manager.
Perform Initial Configuration Using the CLI
Connect to the threat defense CLI to perform initial setup. When you use the CLI for initial configuration,
only the Management interface and manager access interface settings are retained.When you perform initial
setup using the device manager, all interface configuration completed in the device manager is retained when
Cisco Firepower 1010 Getting Started Guide
136
Perform Initial Configuration Using the CLI, on page
you complete the startup script.
Perform Initial Configuration Using the Device Manager, on page
registration_key, and nat_id parts of the command into the Management Center/CDO Hostname/IP
Address, Management Center/CDO Registration Key, and NAT ID fields.
). Labels are applied to the device after it's onboarded to CDO.
Threat Defense Deployment with CDO
136—Copy this command at the FTD CLI after
141—Copy the cdo_hostname,