Central Administrator Pre-Configuration - Cisco FPR1010-ASA-K9 Getting Started Manual

Central Administrator Pre-Configuration

CLI
CDO
Physical Tasks
Physical Tasks
Physical Tasks
CDO
CLI or Device Manager
CDO
Central Administrator Pre-Configuration
This section describes how to obtain feature licenses for your firewall; how to install a new software version
before you deploy; and how to log into CDO.
Obtain Licenses
All licenses are supplied to the threat defense by CDO. You can optionally purchase the following feature
licenses:
• IPS—Security Intelligence and Next-Generation IPS
• Malware Defense—Malware defense
• URL—URL Filtering
• Cisco Secure Client—Secure Client Advantage, Secure Client Premier, or Secure Client VPN Only
• Carrier—Diameter, GTP/GPRS, M3UA, SCTP
For a more detailed overview on Cisco Licensing, go to
Before you begin
• Have a master account on the
Cisco Firepower 1010 Getting Started Guide
122
(Optional) Check the Software and Install a New Version, on page
Log Into CDO, on page 125.
Install the firewall. See the hardware installation
Cable the Firewall, on page
Power on the Firewall, on page
Onboard a Device with the Onboarding Wizard, on page
• Perform Initial Configuration Using the CLI, on page
• Perform Initial Configuration Using the Device Manager, on page
Configure a Basic Security Policy, on page
Smart Software
guide.
133.
134.
145.
cisco.com/go/licensingguide
Manager.
Threat Defense Deployment with CDO
124.
135.
136.
141.