Cisco FPR1010-ASA-K9 Getting Started Manual page 156

Configure SSH on the Manager Access Data Interface
Step 3
Click Add.
The rule is added to the Rules table.
Step 4 Click Save.
Configure SSH on the Manager Access Data Interface
If you enabled management center access on a data interface, such as outside, you should enable SSH on that
interface using this procedure. This section describes how to enable SSH connections to one or more data
interfaces on the threat defense. SSH is not supported to the Diagnostic logical interface.
Note
The Management interface is separate from the other interfaces on the device. It is used to set up and register
the device to the management center. SSH for data interfaces shares the internal and external user list with
SSH for the Management interface. Other settings are configured separately: for data interfaces, enable SSH
and access lists using this screen; SSH traffic for data interfaces uses the regular routing configuration, and
not any static routes configured at setup or at the CLI.
For the Management interface, to configure an SSH access list, see the configure ssh-access-list command
in the
network static-routes command. By default, you configure the default route through the Management interface
at initial setup.
To use SSH, you do not also need an access rule allowing the host IP address. You only need to configure
SSH access according to this section.
You can only SSH to a reachable interface; if your SSH host is located on the outside interface, you can only
initiate a management connection directly to the outside interface.
Note
Cisco Firepower 1010 Getting Started Guide
154
SSH is enabled by default on the Management interface; however, this screen does not affect Management
SSH access.
Cisco Secure Firewall Threat Defense Command
After a user makes three consecutive failed attempts to log into the CLI via SSH, the device terminates
the SSH connection.
Threat Defense Deployment with CDO
Reference. To configure a static route, see the configure