Cisco FPR1010-ASA-K9 Getting Started Manual page 148

Configure Interfaces
Configure Interfaces
Add the VLAN1 interface for the switch ports or convert switch ports to firewall interfaces, assign interfaces
to security zones, and set the IP addresses. Typically, you must configure at least a minimum of two interfaces
to have a system that passes meaningful traffic. Normally, you would have an outside interface that faces the
upstream router or internet, and one or more inside interfaces for your organization's networks. By default,
Ethernet1/1 is a regular firewall interface that you can use for outside, and the remaining interfaces are switch
ports on VLAN 1; after you add the VLAN1 interface, you can make it your inside interface. You can
alternatively assign switch ports to other VLANs, or convert switch ports to firewall interfaces.
A typical edge-routing situation is to obtain the outside interface address through DHCP from your ISP, while
you define static addresses on the inside interfaces.
The following example configures a routed mode inside interface (VLAN1) with a static address and a routed
mode outside interface using DHCP (Ethernet1/1).
Procedure
Step 1
Choose Devices > Device Management, and click the Edit ( ) for the device.
Step 2 Click Interfaces.
Step 3
(Optional) Disable switch port mode for any of the switch ports (Ethernet1/2 through 1/8) by clicking the
slider in the SwitchPort column so it shows as disabled (
Step 4 Enable the switch ports.
a) Click the Edit ( ) for the switch port.
Cisco Firepower 1010 Getting Started Guide
146
Threat Defense Deployment with CDO
).