Cisco FPR1010-ASA-K9 Getting Started Manual page 43

Threat Defense Deployment with the Management Center
• Source Zones—Select the inside zone from Available Zones, and click Add to Source.
• Destination Zones—Select the outside zone from Available Zones, and click Add to Destination.
Leave the other settings as is.
Step 3
Click Add.
The rule is added to the Rules table.
Step 4
Click Save.
Deploy the Configuration
Deploy the configuration changes to the threat defense; none of your changes are active on the device until
you deploy them.
Procedure
Step 1 Click Deploy in the upper right.
Figure 9: Deploy
Step 2
Either click Deploy All to deploy to all devices or click Advanced Deploy to deploy to selected devices.
Deploy the Configuration
Cisco Firepower 1010 Getting Started Guide
41