Configure A Basic Security Policy - Cisco FPR1010-ASA-K9 Getting Started Manual

Table of Contents

Advertisement

Configure a Basic Security Policy

For more troubleshooting information, see https://cisco.com/go/fmc-reg-error.
Configure a Basic Security Policy
This section describes how to configure a basic security policy with the following settings:
• Inside and outside interfaces—Assign a static IP address to the inside interface, and use DHCP for the
• DHCP server—Use a DHCP server on the inside interface for clients.
• Default route—Add a default route through the outside interface.
• NAT—Use interface PAT on the outside interface.
• Access control—Allow traffic from inside to outside.
To configure a basic security policy, complete the following tasks.
Configure Interfaces (6.5 and Later)
Add the VLAN1 interface for the switch ports or convert switch ports to firewall interfaces, assign interfaces
to security zones, and set the IP addresses. Typically, you must configure at least a minimum of two interfaces
to have a system that passes meaningful traffic. Normally, you would have an outside interface that faces the
upstream router or internet, and one or more inside interfaces for your organization's networks. By default,
Ethernet1/1 is a regular firewall interface that you can use for outside, and the remaining interfaces are switch
ports on VLAN 1; after you add the VLAN1 interface, you can make it your inside interface. You can
alternatively assign switch ports to other VLANs, or convert switch ports to firewall interfaces.
A typical edge-routing situation is to obtain the outside interface address through DHCP from your ISP, while
you define static addresses on the inside interfaces.
Cisco Firepower 1010 Getting Started Guide
28
outside interface.
Configure Interfaces (6.5 and Later), on page 28
Configure Interfaces (6.4), on page
Configure the DHCP Server, on page
Add the Default Route, on page
Configure NAT, on page
Allow Traffic from Inside to Outside, on page
Deploy the Configuration, on page
Threat Defense Deployment with the Management Center
32.
35.
36.
38.
40.
41.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Firepower 1010

Table of Contents