Table of Contents
Advertisement
Chapter 3 Installing the Library
Connecting the Library to the Host Controller
30
Quantum|ATL 7100 Series Facilities Planning and Installation Guide
Connect one library-to-host SCSI cable to the library rear panel
4
(see
figure
11) at SCSI PORT 1.
Figure 11 shows a two-wire, four drive configuration.
Note:
If you are using a different configuration, the cable
connections will be different. See Appendix A for
more information about different configurations.
Install the SCSI terminator (provided in the accessories kit) for
5
host SCSI cable 1 on the rear panel connector labeled SCSI
PORT 2 .
Connect the other library-to-host SCSI cable to the library rear
6
panel at SCSI PORT 3 .
Install the SCSI terminator (provided in the accessories kit) for
7
host SCSI cable 2 on the rear panel connector labelled SCSI
PORT 4 . Refer to
On the library rear panel, set the
8
position.
After several seconds, verify that the SDA shows System On-
9
line.
Apply power to all other SCSI targets connected.
10
Apply power to the host.
11
figure
11.
POWER
button to the " | " (on)
Advertisement
Table of Contents
