Table of Contents
Advertisement
Packaging the Library for Reshipment
Quantum|ATL 7100 Series Facilities Planning and Installation Guide
If it becomes necessary to crate the library for shipment, use the
procedure below and refer to the figures in this chapter.
This procedure assumes that all cartridges have been
Note:
removed, power is off and cables are disconnected.
Observe proper ESD protective measures to prevent
Caution:
damage to the library.
Open the storage array door.
1
Gently lift the extension axis up and place the vertical axis
2
block in position (see
the bottom position.
Install both the top and bottom horizontal axis blocks.
3
Gently slide the robotic mechanism towards the rear of the
4
library so that is up against the horizontal axis packing blocks.
Install the tie-wraps securing the extension axis for shipment
5
(see
figure
8).
Close the storage array door.
6
Raise the leveling feet by rotating each foot counterclockwise
7
(as viewed from above) until they are fully retracted.
Move the library to the crating area observing all guidelines
8
described in
Moving the Library to the Final Installation Area
on page 17.
Slide out the two pallet ramp sections (located underneath the
9
library) and secure them to the pallet using the Velcro straps
(see
figure 7
on page 15).
Unfold the shipping bag and align the white tape to the pallet
10
bottom with respect to where the library casters will roll onto
the pallet.
Chapter 2 Unpacking and Moving the Library
Packaging the Library for Reshipment
figure
9), then lower the extension axis to
2
21
Advertisement
Table of Contents
