Table of Contents
Advertisement
Check the gauge on the level. If the left side of the library is
7
level, proceed to step 8. If it is not level:
Determine the tilt of the library and adjust the appropriate
a
left side foot with the wrench, checking the gauge each
time that a foot is rotated ¼ turn.
Repeat step 7 until the left side is level, then continue to the
b
next step.
Center the carpenter's level on the top-rear edge of the library.
8
Check the gauge on the level. If the rear of the library is level,
9
proceed to step 10. If it is not level:
Determine the tilt of the library and adjust the appropriate
a
rear foot with the wrench, checking the gauge each time
that a foot is rotated ¼ turn.
Repeat step 9 until the rear is level, then continue to the
b
next step.
Center a carpenter's level on the top right-side edge of the
10
library.
Check the gauge on the level. If the right side of the library is
11
level, proceed to step 12. If it is not level perform the following:
Determine the tilt of the library and adjust the appropriate
a
right-side foot with the wrench, checking the gauge each
time that a foot is rotated ¼ turn.
Repeat step 11 until the right side is level, then continue to
b
the next step.
After individually leveling each side, return to the front of the
12
library. Center the level on the top-front edge and check the
gauge. Make any minor adjustments necessary to the feet and
then move in a clockwise fashion around the library, repeating
this step, until the library is level.
Quantum|ATL 7100 Series Facilities Planning and Installation Guide
Chapter 3 Installing the Library
Leveling the Library
25
Advertisement
Table of Contents
