Welding Parameter Ignition Time "Tzn" Diagram - EWM Saturn drive 41 WE Operating Instructions Manual

Table of Contents

Advertisement

Machine description – quick overview
Machine control – Operating elements
4.3.3.7

Welding parameter ignition time "tZn" diagram

In the ignition time, the wire feed continues to run at creep speed after the arc is ignited;
the ignition behaviour is improved with the optimum setting.
The factory setting is that the ignition time is already optimally preset for various materials. The
process described below is always used if there is a pause between welding processes of not
less than 1.5 seconds.
Legend with an explanation of symbols can be found in the MIG/MAG function sequences /
operating modes chapter.
34
NOTE
Figure 4-13
099-005172-EW501
21.09.2011

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Saturn drive 41 WE and is the answer not in the manual?

This manual is also suitable for:

Saturn drive 41l weM1.02M2.20M2.40

Table of Contents