Table of Contents
Advertisement
Note:
Under normal conditions your remote control has been paired with the USB adapter in the factory
and therefore the "Air mouse" function of your remote control will directly work for your receiver.
In case you can only use the q button on the remote control and none of the other buttons have
a function, or in case the red LED on the remote control keeps blinking, it could be that the pairing
between the remote control and the USB adapter is not correct.
In that case you need to pair the USB adapter to the remote control manually:
1. Remove the USB adapter from the USB slot on the receiver.
2. Make sure the receiver is switched ON.
3. Remove the batteries from the remote control and insert them again. The LED on the remote
control starts flashing.
4. Press and hold the OK and
remote control flashes more quickly.
5. Insert the USB adapter into a free USB port of the receiver and wait until the LED on the remote
control stops flashing (fig. 6).
6. Now the remote control is paired with the USB adapter.
Note
3.0 CONNECTIONS
Warning
3.1 Connecting the antenna
To receive digital signals, your receiver has to be connected to a terrestrial indoor or outdoor
antenna. Use the antenna cable to connect the antenna with the ANT IN connector on the back of
your receiver. Please ensure that a properly shielded antenna cable and suitable connectors are used.
If you are using an active indoor or outdoor antenna you can support it with power via the receiver.
As this function uses more power as normal pressing of buttons we
recommend using Alkaline batteries to ensure longer operation time
of your remote control. When the batteries are almost empty the LED
indication on the remote control will start blinking for 15 seconds after you
press any button.
buttons at the same time for a few seconds. The LED on the
The function of Standby on the remote control is limited or not possible
if there are obstacles in front of the remote control sensor on the front
panel of the receiver. If only the Standby button is working and there is no
reaction when pressing any other button it could be that the batteries are
empty or the USB adapter was removed or, as mentioned above, you need
to pair the USB adapter to the remote control manually.
Please make sure that any connection devices or equipment are
disconnected from their main power before you make connections
between them and your receiver.
Fig. 7
7
Advertisement
Table of Contents
