Table of Contents
Advertisement
Run on Start-up
Antenna Power:
Loop Through:
Auto Scan:
Factory Reset
Warning
7.4 Recording functions
The receiver supports instant recording, recording via timer and recordings booked via the Electronic
Programme Guide (EPG). First select the storage device on which you like to store the recordings
before you can use the recording functions. Connect the storage device and select PVR settings in the
DTV settings menu. After you have made recordings you can watch them by selecting the option PVR
from the DTV menu.
Press OK to open this menu. Select the recording you want to watch. At the right side of this menu
you can see the date and size of the recording. Press OK to start playback and use the multimedia
buttons for forwards, backwards, pause and stop. Press the RED Delete button to remove the
selected recording from the list.
7.5 Installation
In this menu you can select Country, Antenna power, LCN modes and search for channels.
Below in the screen you will find level and quality bars for optimizing the best signals of your
terrestrial antenna.
Country Settings:
Antenna Power:
LCN:
Auto Scan:
Select On for starting the DTV immediately after you power ON the box with
main power. Select Off to start in the Android mode.
Set to On if you use an active antenna.
This option allows activating or deactivating of the
ANT OUT to loop antenna signals to another device such as a TV or another
receiver.
Set this function to On to start searching automatically for new available
channels if the broadcaster is signalling this. In some areas where more
broadcasters can be received it is better to select Off to avoid updates of the
list many times a day.
This function resets your DTV receiver settings back to the default factory
settings. Press OK and enter the PIN code to continue. Select OK to confirm
executing the factory reset. This option will delete all your channels, favourite
lists and settings from the DTV. The receiver will reboot and start with the First
Installation menu of the DTV part.
A factory reset will permanently delete all your personal settings, timers
and stored channels. The Android part is kept as it is. Please consider this
before you perform a factory reset.
Select your region.
Set to On if you use an active antenna. When set to On, 5 V will be present at
the ANT IN connector of the receiver. Select Off for passive antennas.
Set LCN (Logical Channel Numbering) to On to activate operator defined
channel numbering or Off to store channels in found order. Sorting of
channels in the channel list with LCN is not possible.
Select to start searching all frequencies for available channels. All stored
channel from before will be deleted.
19
Advertisement
Table of Contents
