Table of Contents
Advertisement
Country Settings:
Picture size:
Zap Mode:
Subtitle:
LCN:
Select Next and confirm with OK to go to step 2.
NOTE
Step 2:
The receiver will show the Aerial Adjustment screen. This part of the wizard is of great help when
setting up your antenna system.
Use p/q to move the highlight to the setting you wish to alter and use tu to change values. The
following settings are available:
Antenna Power:
Channel No.:
Scan Type:
When all settings have been made, select Next and press OK to start scanning.
The receiver will search for all available channels now. When the scanning is finished, the receiver
switches to viewing mode.
After the above steps have been made the receiver will enter viewing mode and you can use and
enjoy it. Should some steps not be set as you wish or if you like to restart the wizard, you can do so
from the DTV part. Please press
Select System and Factory Reset. After entering the PIN code the unit is set back to default and all
previous channels and settings will be deleted. The unit will return to the first installation wizard of
DTV.
Note
10
Select your region.
Select Full for the official size or Auto to adjust size to your screen.
Select Black Screen to get a black screen between zapping through the
channels. Select Hold Screen to hold the last watched screen between
zapping through the channels.
Select Off or the subtitle language you like to display.
Local Channel Numbering. Select Off to store all found channels into channel
list order they are found. Select On to store channels into channel list in
the operator defined order. This automatic sorting is only possible if your
operator supports this function.
An incorrect country selection can lead to missing channels or channels
being stored on wrong positions in the channel list.
Set to On if you use an active antenna. When set to On, 5 Volt will be present
at the ANT IN connector of the receiver. Select Off for passive antennas.
Select a channel that is known to carry a broadcast in your region. The Signal
Strength and Signal Quality bars give a visual indication of the reception.
Adjust your antenna to obtain maximum signal strength and quality.
Select All to store scrambled and Free-To-Air channels or select FTA to store
only Free-To-Air channels. Note: Scrambled channels cannot be viewed with
this receiver.
and select DTV settings and confirm with OK to enter.
The Android part is kept as it is and will not be restored to default.
Restoring Android to default can be done in the Android system settings
menu itself and will reset everything, including DTV.
Advertisement
Table of Contents
