Panasonic WJ-SX550B Operating Instructions Manual page 91

OPERATING PROCEDURE
Before starting the following procedures, all system compo-
nents should be turned on.
Log-in
1. Turn on the power switches of all system components.
Caution: If the WJ-AD550 Extension Unit is used in the
system, turn the Extension Unit power on before
turning on the power of the WJ-SX550B Matrix
Switcher.
2. Turn on the power of the system controller by pressing
the Controller On/Off Switch located on the rear of the
System Controller to the ON position.
The following displays appear on the LCD display.
Initial
9600 BPS
Log-in
3. Press the CAM (SET) key, the Operator No. display
now appears on the LCD display.
Log-in
MON
ESC
Operator No :
93
Check
1 2 3
4 5 6
7 8 9
0
CAM
SET
4. Select your registered Operator Number (up to 30) by
pressing the Numeric keys, then press the CAM (SET)
key.
The initial factory setting is 1.
Operator No :
1 2
4 5
7 8
0
MON
ESC
Operator No : 1
See page 79 for details on registering operator num-
bers.
5. Select your registered Password (five digits) by press-
ing the Numeric keys.
The initial factory setting is 12345.
Password
1
4
7
MON
ESC
Welcome
See page 79 for details on registering password num-
bers.
Note: If the Auto Log-in setting is set to On mode, any
operator can Log-in automatically as any operators
previously.
Refer to the Auto Log-in Setting on page 122.
The Auto Log-in function may not work, if a previ-
ous operator has not logged out properly. In this
case, follow the above procedure to log in manually.
3
6
9
CAM
SET
:
....
2 3
5 6
8 9
0
CAM
SET
5