Panasonic WJ-SX550B Operating Instructions Manual page 45

INSTALLATIONS
The installation described below should be made by qualified service personnel or system installers and should con-
form to all local codes.
WV-CU550B System Controller
Replacing the Side Panels with the optional WV-Q62E Rack Mounting Brackets
1. Remove both the left and right side panels of the System Controller by removing four screws.
2. Remove the Palm-rest located on the front of the System Controller by removing two screws.
3. Place the Rack Mounting Brackets on both sides of the System Controller and tighten with the four supplied screws.
4. Install the System Controller with Rack Mounting Brackets in the rack by using four screws (procured locally).
Palm-rest
WJ-SX550B Matrix Switcher
WJ-AD550 Extension Unit
Mounting into the Rack
1. Remove four rubber feet by removing four screws from
the bottom of the Matrix Switcher (Extension Unit).
2. Install the Matrix Switcher (Extension Unit) in the rack
securing it with eight screws (not included).
Cautions
• The cooling fans inside the Matrix Switcher (or Extension Unit) are subject to wear and need to be replaced periodically.
• Do not block the ventilation opening or slots on the cover to prevent the temperature from rising inside the unit.
Always keep the temperature in the rack within 45˚C (113˚F).
• If the rack is subject to vibration, secure the rear of the unit to the rack using additional mounting brackets (procured
locally).
46
Side Panel
Remove screws.
Rack Mounting Bracket
Rubber
feet
Rack Mount Screws
Rack Mount Screws
Rack Mount Screws
Tighten
screws.
Remove Screws.
3
Rubber
feet