Panasonic WJ-SX550B Operating Instructions Manual page 118

5. Select the Camera Position Number by pressing the
Numeric keys.
After completing the above steps, press the CAM
(SET) key to execute the selection.
If a mistake was made in the above steps, press the
Escape MON (ESC) key to cancel the selection.
C
F1 F2
Note: Up to 1 000 positions can be registered on this
menu.
If an attempt is made to register more than 1 000
positions, "Data Full" appears on the LCD display.
6. Repeat the above steps for other camera positions.
When satisfied with all positions, press the Function
(F4) button to exit from the programming mode.
Delete Camera Position Number
1. Select the desired monitor.
Refer to the Monitor Selection.
2. Select the CAM-P (D5) Menu shown below on the LCD
display by pressing the appropriate Direction buttons.
D5
CAM-P Menu
Set Clear Test Mode
F1 F2
3. Pressing the Function (F2) button will display the menu
shown below on the LCD display.
F1 F2
4. Enter the camera position number to be deleted by
pressing the Numeric keys, and then press the CAM
(SET) key. The picture at the selected camera position
appears on the active monitor, and the LCD display
reads as shown below.
C 01 Pre64 CAM-P9999
Input OK?-->Set/Esc
F1 F2
120
Exit
F3 F4
F3 F4
CAM-P
Exit
F3 F4
F3 F4
5. Confirm the display on the LCD display, then press the
CAM (SET) key to delete the selected Camera Position
Number.
If a mistake was made in the above steps, press the
MON (ESC) key to cancel the selection.
6. Repeat the above steps for other camera position num-
bers.
When satisfied with all positions, press the Function
(F4) button to exit from the programming mode.
F1 F2
Camera Position Test Mode
1. Select the desired monitor.
Refer to the Monitor Selection.
2. Select the CAM-P (D5) Menu shown below on the LCD
display by pressing the appropriate Direction button.
D5
CAM-P Menu
Set Clear Test Mode
F1 F2
3. Pressing the Function (F3) button will display the menu
shown below on the LCD display.
Test1 CAM-P----
Act
F1 F2
4. Press the Function (F1) button to toggle the test mode
on and off.
If On mode is selected, the picture at each of the
selected camera positions is displayed on the active
monitor at intervals of 3 seconds, proceeding from the
lowest camera position number to the highest.
On:
Off:
CAM-P
Exit
F3 F4
F3 F4
Exit
F3 F4
Act
Act
5