Panasonic WJ-SX550B Operating Instructions Manual page 28

WV-PB5504AE Video Output Board
Appearance
q Alarm Output/Reset Output Connector (ALARM OUT/RESET OUT)
External Timing Input Connector (EXT TIMING IN)
Recover Input Connector (RECOVER IN)
ALARM OUT: When the Matrix Switcher receives an alarm from the WV-PB5564E
Alarm Board or camera site receivers WV-RC100, WV-RC150 or WV-RC170, the
alarm output signal is provided at this connector for the Time Lapse VTR.
The active pin number of the alarm output depends on the alarm mode set by the
on-screen program (Mode-1, Mode-2, Mode-3).
RESET OUT: When the Matrix Switcher resets the activated alarm, the alarm reset out-
put signal, either Open Collector or pulse, is provided at this connector for the
Time Lapse VTR.
EXT TIMING IN: The camera switching interval (Sequential Dwell Time) can be syn-
chronized with the lapse mode set on the Time Lapse VTR.
EXT. TIMING IN 1 controls Monitor 1 output, EXT. TIMING IN 2 controls Monitor 2
output, etc.
Supply the camera switching pulse from the Time Lapse VTR to this connector.
Minimum duration for camera switching pulse needs to be one (1) second or more.
RECOVER IN: This connector accepts the alarm recover signal from the Time Lapse
VTR.
13
25
12
24
11
23
10
22
9
21
8
20
7
19
6
18
5
17
4
16
3
15
2
14
1
w Monitor Input/Output Connector (MONITOR IN/OUT)
OUT: Outputs the video signal selected by the Matrix Switcher for the video monitor.
IN: This connector is used for video input from a VTR or for expanding the system to
128 camera inputs.
29
Pin No. Designation
1 ALARM OUT 1
2 RESET OUT 1
3 RECOVER IN 1
4 Ground
5 EXT TIMING IN 1
6 Ground
7 ALARM OUT 2
8 RESET OUT 2
9 RECOVER IN 2
10 Ground
11 EXT TIMING IN 2
12 (+5V DC)
13 ALARM OUT 3
14 RESET OUT 3
15 RECOVER IN 3
16 Ground
17 EXT TIMING IN 3
18 Ground
19 ALARM OUT 4
20 RESET OUT 4
21 RECOVER IN 4
22 Ground
23 EXT TIMING IN 4
24 Ground
25 Ground
OUTPUT
q
ALARM OUT
RESET OUT
EXT TIMING IN
RECOVER IN
MONITOR
IN
1
OUT
IN
2
OUT
w
IN
3
OUT
IN
4
OUT
2