Panasonic WJ-SX550B Operating Instructions Manual page 23

Board Setting
Before installing this board, the following settings should be made by qualified service personnel or system installers.
1. Confirm that Switches (SW2) on the board are set as
follows.
These switches are used only for factory test.
Always keep these switches in the positions below
in the field.
2. Set switch (SW4) on the board to select either VD or VS
for the Sync input signal, if applicable.
The factory default setting is VS.
24
CN12
SW4
CN14
Note
SW2
SW4
VS
SW4
VD
CN13
SW2
3. Position jumper connectors (CN12) on the board to
open connection position when a printer is connected
to the board.
4. Position jumper connector (CN13) on the board to the
"C/L" position when the setup menu tables are not
clearly displayed on the colour monitor.
The factory default setting is "B/W".
5. Position jumper connector (CN14) on the board to
select either VD Output or Status Display Output for the
VD Output Connector.
The factory default setting is VD.
R
G
CN12
B
SYNC
CN13
B/W
CN13
C/L
CN14
GRAPHIC
CN14
VD
2