Panasonic WJ-SX550B Operating Instructions Manual page 11

Sequence
This system has three kinds of sequential modes: Program, Tour and Group
Program Sequence
The Program Sequence is a series of 64 steps assigned to a particular monitor.
Each step has a Camera and Dwell Time assigned to it.
In the Program Sequence, each monitor has its own specified sequence operation as shown below.
• Auto Skip Function
The Auto Skip function is available in sequence mode. If there is no video signal present at a step, the sequence will auto-
matically skip that step.
This function is enabled from the Set Up Menu.
• Dwell Time
The amount of time each camera view is displayed on the monitor (Dwell Time) can be set from 1 second to 30 seconds in
1-second increments.
This function is set from the Set Up Menu.
External Timing, which is controlled from the Time Lapse VTR, can also be selected from the Set Up Menu.
Monitor 1
Dwell time: 3 sec.
Step 1
Tour Sequence
A Tour Sequence consists of 64 steps.
Each step has a Camera, Dwell Time, Auxiliary Control and Pan/Tilt Preset assigned to it.
A total of 32 Tour Sequences can be programmed on the Set Up Menu.
A Tour can be assigned to any monitor.
Monitor 1
Dwell time: 5 sec.
Step 1
11
Monitor 1
Dwell time: 3 sec.
Step 2
s
Tour Sequence
T1 T2 T3 T4 T5 T6 T7
T9 T10 T11 T12 T13 T14 T15 T16
T17 T18 T19 T20 T21 T22 T23 T24
T25 T26 T27 T28 T29 T30 T31 T32
32 Tours to Any Monitor
Monitor 1
Dwell time: 3 sec.
Step 2
s
Monitor 1 Monitor 1
Dwell time: 3 sec. Dwell time: 3 sec.
Step 3 Step 4
s s
T8
Monitor 1 Monitor 1
Dwell time: 10 sec. Dwell time: 5 sec.
Step 3 Step 4
s s
Monitor 1
Dwell time: 3 sec.
Step 5
s
Monitor 1
Monitor 2
Monitor 3
Monitor 4
Monitor 15
Monitor 16
Monitor 1
Dwell time: 3 sec.
Step 5
s
1