Panasonic WJ-SX550B Operating Instructions Manual page 9
System 500 matrix switcher
Hide thumbs
Also See for WJ-SX550B:
- Operating instructions manual (132 pages) ,
- Operating instructions manual (132 pages)
Table of Contents
Advertisement
FEATURES
Log-in
To operate the Matrix Switcher System 500, a registered
operator must first supply his/her Operator Number and
Password to the system.
The operator number and password are established by
using the REGISTRATION table. See page 14 for more
details on operator number registration.
If an attempt is made to enter an operator number and
password that do not match with the registered operator
numbers and passwords, entry into this system is denied.
As shown in the examples below, there are 2 additional
attributes associated with an operator: operator level and
priority. These items are described in more detail on page
14.
Notes:
• Factory Default Setting
are registered to allow access for first time system
programming.
• An operator can be logged-in to this system from
several system controllers.
• If the main power of the Matrix Switcher is turned
off, log-in procedures must be performed again.
• If power to the system controller is turned off, the
system controller will record operating status when
power is resupplied.
9
Operator name:
Mike
Operator Number:
1
Operator Level:
1
Password:
07171
Priority:
1
Operator name:
Robert
Operator Number:
15
Operator Level:
13
Password:
11524
Priority:
8
Operator Number: 1
Password:
12345
Camera and Monitor Selection
After logging in, the desired camera and monitor combina-
tion can be selected.
Basically, any combination of camera and monitor, which
are connected to the Switcher, can be selected as shown
below.
Camera-1 Camera-2
WV-RC150
3
2
1
System Controller WV-CU
Controller
General Procedures
1. Select the desired monitor. (Monitor and controller
are linked.)
2. Select the desired camera. (Camera and controller
are linked.)
3. The picture of the selected camera view is dis-
played on the selected monitor.
Monitor Selection
By selecting the monitor with the System Controller, it is
linked with the System Controller.
At this time, the camera output signal that was last supplied
to the monitor is displayed.
Press the Numeric keys (1 to 16), then press the MON
(ESC) key to select the desired monitor.
1
4
7
MON
ESC
For example: When selecting monitor Number 5:
Press 5, then press the MON (ESC) key.
Monitor-1
Monitor-2
WJ-SX550B
550
B
2
3
5
6
8
9
0
CAM
SET
1
Advertisement
Table of Contents
