Panasonic WJ-SX550B Operating Instructions Manual page 117

Clearing Preset Settings
1. Select the desired monitor and camera.
Refer to the Monitor Selection and camera Selection.
2. Select the Preset (D3) Menu on the LCD display by
pressing the appropriate Direction buttons.
D3
Preset Menu:CS500
On
F1 F2
3. Press the Function (F1) button to select the Preset
Program Mode.
The Preset Program Menu is displayed on the active
monitor, and the LCD display reads as shown below.
4. Move the cursor to SET UP PRESET by moving the
Joystick Controller, then press the CAM (SET) key.
The PRESET NUMBER SET table appears on the active
monitor.
5. Move the cursor to the desired preset number by mov-
ing the Joystick Controller, then press the CAM (SET)
key to select the Preset Position Setting table shown
below.
CAM
POSITION NUMBER : 12
Preset/BLC Clear
Pre
F1 F2
6. Press the Function (F1) button to clear the presets for
the selected position number.
To clear only the BLC setting, press the Set CAM (SET)
key to select the Preset BLC Setting table, and then
press the Function (F2) button instead of (F1).
7. Pressing the MON (ESC) key repeatedly will return to
the previous setup table or menu.
119
Refresh
F3 F4
: CameraTitle
PAN/TILT/ZOOM/FOCUS
SET UP POSITION
BLC
F3 F4
Camera Position Number
Setting
The following function is available only when the Mode
Selection Switch located on the rear of the controller is set
to CAM-P Mode, and cameras equipped with the specific
feature are used.
Refer to the Mode Selection on page 52.
Register Camera Position Number
1. Select the desired monitor.
Refer to the Monitor Selection.
2. Select the CAM-P (D5) Menu on the LCD display by
pressing the appropriate Direction button.
D5
CAM-P Menu
Set Clear Test Mode
F1 F2
3. Pressing the Function (F1) button will display the menu
shown below on the LCD display.
Select the camera number by pressing the Numeric
keys, then press the CAM (SET) key.
C
C 01 Pre
4. Select the preset position number by pressing the
Numeric keys, then press the CAM (SET) key.
The picture at the selected camera preset position
appears on the active monitor, and the LCD display
reads as shown below.
C 01 Pre64 CAM-P
Input OK?-->Set/Esc
F3 F4
Exit
Exit
5