Yaesu WIRES-X FT3D Instruction Manual page 59

8. 【This setting is necessary only when using the FT3D
or FT2D transceiver】
Click the [Listen] tab and check "Listen to this device".
Depending on your computer, there may be no [Listen]
tab. In that case, please proceed to step 9 as it is.
9. Press the [OK] button several times to close all Windows
setting screens.
The microphone input level adjustment of the personal com-
puter is completed with the above.
Continue to adjust the speaker output level of the personal
computer.
⿟ Adjust speaker output level of PC
Adjust the volume level so that the "VOL bar graph" is 50% by turning the VOL knob of FT2D, and then make the following
adjustments. Also, when using FT2D as a transceiver of a Portable Digital Node station, adjust it so that it is almost the same
volume level.
1. Click "OS Volume Mixer".
The WINDOWS "Volume Mixer - Speakers" window
opens.
2. Click [Start] in the "Test Tone" area.
A test tone is output.
3. Adjust the volume level of "WIRES-X" on the "Volume
Mixer - Speakers" screen so that the test sound that you
hear from the PC speaker will be easy to hear.
When adjustment is completed, click the [Start] button
again, to stop the test sound.
• If the speaker output is muted, click the icon " " at
the bottom of the slider to release the mute.
• If the volume level of "Speaker/Headphone" is
decreased, adjust the volume so that it is easy to hear.
58