Yaesu WIRES-X FT3D Instruction Manual page 24

Function
Enters the Set mode*
Enters the BACKTRACK (COMPASS) screen
Registering to Memory Channel
Displays the Function Menu Screen
Selects the Transmission Power Level
Recalls the "HOME" channel
Reverses the transmit and receive frequencies
Squelch OFF
Adjusts the squelch level
Switches Busy detection between "Noise squelch" and
"DG-ID number match".
* Some setting items in the set mode are automatically set for the Portable Digital Node function, so these
settings cannot be used.
 FTM-300D
On the frequency setting screen, you can set and operate the following with the transceivers key and DIAL knob settings.
Function
Switches between the Access Point and the Direct Operation Press the A/B key
Starts operation for the Portable Digital Node
Sets the operation frequency
Selects the operating band
Recalls the "HOME" channel
Switches between the VFO mode and the Memory
Channel mode
Registering to Memory Channel
Sets the transmit and receive DG-ID number
Enters the Setup menu*
Enters the BACKTRACK (COMPASS) screen
Selects the Transmission Power Level
Reverses the transmit and receive frequencies
Squelch OFF
Adjusts the squelch level
Switches Busy detection between "Noise squelch" and
"DG-ID number match".
* Some setting items in the set mode are automatically set for the Portable Digital Node function, so these
settings cannot be used.
Key or Dial
Press and hold the DISP key
Press the DISP key
Press and hold the F(MW) key
Press the F(MW) key
Touch [TX PWR] in the Function Menu Screen or press
the P4 key on the microphone (by default setting)
Touch [HOME] in the Function Menu Screen or press
the P2 key on the microphone (by default setting)
Touch [REV] in the Function Menu Screen
Press the P1 key on the microphone (by default setting)
Touch [SQL] on the LCD screen, then rotate the Band
A DIAL knob (Upper)
Press and hold the Band B DIAL knob (Lower)
Key or Dial
Press the DX key or press the P3 key on the micro-
phone (by default setting)
Rotate the DIAL knob or ten key on the microphone
Press the BAND key
Press the P2 key on the microphone (by default setting)
Press the V/M (MW) key
Press and hold the V/M key
Press and hold the GM key
Press and hold the F(SETUP) key
Press the DISP key
[TXPWR] on the Function Menu Screen or press the
P4 key on the microphone (by default setting)
Press and the P2 key ~ P4 key on the microphone*
*Setting of "REVERSE" function is necessary for P2 ~ P4
keys in set mode.
Press and the P2 key ~ P4 key on the microphone*
*Setting of "SQL OFF" function is necessary for P2 ~ P4
keys in set mode.
Press the SQL key, then rotate the DIAL knob
Press and hold the A/B key
23