Yaesu WIRES-X FT3D Instruction Manual page 33

While operating the portable node, the following functions may be set and operated on the portable node FTM-300D
transceiver.
Function
Return to the transceiver setting screen
Adjusts the squelch level
Enters the BACKTRACK screen
Enters the Set mode*
Displays the Function Menu Screen*
Selects the Transmission Power Level
Selects Speaker Mute
Turning the back light ON and OFF
Disconnects a node or a room on the Internet
* Some items in the Set mode and Function menu are automatically set for the Portable Digital Node function, so the
settings cannot be used.
⿟ Setting the speaker mute
You can mute the audio output of the speaker of the node station FTM-100D transceiver.
You cannot set it in Direct Operation.
Press the [MUTE] key on the microphone each time toggles the mute mode as follows.
 MUTE OFF  MUTE ALL MUTE TX  MUTE RX  MUTE OFF ・・・
MUTE OFF: Disable mute.
MUTE ALL: Mute both the received voice from the C4FM digital station and the voice from the node station on the
Internet.
MUTE RX: Mute the received voice from the C4FM digital station.
MUTE TX:
Mute the voice from the node station on the Internet.
 FTM-100D
1. Press the [DX] key on the portable node FTM-100D transceiver.
The " X " icon flashes on the LCD screen.
• The display screen example uses the "Access Point" screen. In "Direct Operation",
"DIRECT" is displayed instead of frequency
• If the " X " icon does not blink when the [DX] key is pressed, communication between the
transceiver connected to the PC and the WIRES-X software has not been established, so
check the cable connection and USB driver installation.
• To cancel the connection, press and hold the [DX] key.
2. When the operation of the portable node is started, the " X " icon changes from blinking
to lit and the Node ID and the city of its own station are displayed.
Depending on the history of the previously connected node on the internet and the
current connection status of the portable node, one of the following four screens is
displayed.
If the portable node is not connected to a node or a room on the Internet
① When connection history is not stored
The connection destination display will be blank.
② When connection history is stored
The ID of the previously connected ID will blink.
Press the PTT switch to connect to the previously connected ID.
Key or Dial
Press and hold the DX key
Press the SQL key, then rotate the DIAL knob
Press the DISP key
Press and hold the F(SETUP) key
Press the F (SETUP) key
[TXPWR] on the Function Menu Screen or press the P4 key on
the microphone (by default setting)
Press the [MUTE] key on the microphone
Press and hold the DISP key
Press and hold the * key on the microphone
32