Yaesu WIRES-X FT3D Instruction Manual page 31

If the portable node is already connected to a node or a room on the Internet
③ When connected to the same node or room as the ID of the previous connection history
The current connection ID is displayed in white. To communicate with this con-
nection, proceed to "Communicating with other station" (page 44).
If the current connection destination is different from the previous connection
ID, turning the DIAL knob displays the previous connection ID in gray. When the
PTT switch is pressed or [connection ID] is touched, the node will connect [con-
nection ID] is touched, the node will connect to the previous connection destina-
tion.
While operating the Portable Node, may be not possible to switch between "Access Point" and "Direct Operation". Press
and hold the [DX] key to return to the transceiver setting screen, then press the Band B DIAL knob.
While operating the portable node, the following functions may be set and operated on the portable node FTM-400XD/D
transceiver.
Function
Return to the transceiver setting screen
Squelch OFF
Adjusts the squelch level
Enters the BACKTRACK (COMPASS) screen
Displays the Function menu Screen*
Turning the display ON and OFF
Selects the Transmission Power Level
Selects Speaker Mute
Disconnects a node or a room on the Internet
* Some items in the Function menu are automatically set for the Portable Digital Node function, so the settings cannot
be used.
⿟ Setting the speaker mute
You can mute the audio output of the speaker of the node station FTM-400XD/D transceiver.
You cannot set it in Direct Operation.
Touch the [MUTE] on the LCD each time toggles the mute mode as follows.
 MUTE OFF  MUTE ALL MUTE TX  MUTE RX  MUTE OFF ・・・
MUTE OFF:
Disable mute.
MUTE ALL: Mute both the received voice from the C4FM digital station and the voice from the node station on the
Internet.
MUTE RX: Mute the received voice from the C4FM digital station.
MUTE TX: Mute the voice from the node station on the Internet.
When the MUTE setting is enabled, the [MUTE] in orange on the LCD.
Key or Dial
Press and hold the DX key or press the P3 key on the micro-
phone (By default setting)
Press the P1 key on the microphone (By default setting)
Touch [SQL] on the LCD screen, then rotate the DIAL knob
Press the DISP (SETUP) key
Press the F (MW) key
Press and hold the DISP (SETUP) key
Touch [TX PWR] in the Function Menu Screen or press the P4
key on the microphone (By default setting)
Press the [MUTE] on the LCD screen
Press the * key on the microphone (Press and hold)
30
I D : T 0 0 / R X 0 0
4 3 0 8  
J Q 1 Y B F - T I SHINAGAWA-KU
Y A E S U - T U R I Y A E S U - T S U R I 
V / M S Q L M UTE SCOPE
I D : T 0 0 / R X 0 0
4 3 0 8  
J Q 1 Y B F - T I SHINAGAWA-KU
Y A E S U - T S U R I Y A E S U - D R I V E 
V / M S Q L M UTE SCOPE