Table of Contents
Advertisement
EN
V
MAINTENANCE AND CLEANING
Attention! Before any maintenance or cleaning operation, disconnect the
power supply from the appliance (Fig. 2.1 – Fig. 2.2 WARNINGS chapter).
V.1 CLEANING THE EXTRACTOR INDUCTION HOB
Turn off the appliance before cleaning it.
Do not clean the hob if the glass is too hot as there is a risk of burns.
Remove light stains with a cloth dampened with dish detergent diluted in a little water. Then rinse
with cold water and dry the surface thoroughly.
Highly corrosive or abrasive cleaners and cleaning equipment that can cause scratches should be
strictly avoided.
Never use pressure or steam appliances.
Do not use objects that could scratch the ceramic glass.
Make sure the pot is dry and clean. Make sure there are no specks of dust on the glass ceramic hob
or on the pot. Sliding rough pans will scratch the surface.
Spills of sugar, jam, jelly, etc. must be removed immediately. This will prevent damage to the
surface.
Warning! The following products must NOT be used:
Products containing chlorides, especially those containing hydrochloric acid;
Products based on halides;
Products based on hydrogen peroxide;
Bleaches based on hypochlorous acid;
Aggressive products containing acids;
Detergents containing abrasive powder;
Silver cleaning products;
Detergents whose chemical composition is unknown;
Abrasive pads, brushes or discs;
Rough cloths or rough paper;
Tools that have previously cleaned other metals or alloys.
43
Advertisement
Table of Contents
