Table of Contents
Advertisement
EN
The installation is under the sole responsibility of the specialists.
The installer is required to comply with the legislation and standards in force in their country of
origin.
Materials are often used to expand work surfaces in contact with water. To protect the cut edge of
the unit, apply a coat of varnish or special sealant. Particular care must be taken when applying
the adhesive seal supplied with the hob to prevent leaks in the support unit. This seal ensures a
proper seal when used in conjunction with smooth work surfaces.
How to attach the seal:
The
seal
supplied
Its installation must be performed carefully, respecting the following drawing.
Assembly - installation:
· Make sure there is a distance of 50mm between the hob and the wall or sides.
· Ideally the hob should be installed with plenty of space on both sides. There may be a wall to the
rear and tall units or a wall to one side. On the other side, however, no unit or divider should be
higher than the hob.
The unit or support into which the hob is to be installed, as well as the edges of the unit, the
laminate coverings and the glue used to fix them, must be able to withstand temperatures of up to
100°C.
· The edge wall rods must be heat-resistant.
· Do not install the hob above a non-ventilated oven or dishwasher.
with
the
hob
prevents
all
liquid
infiltration
Attach the seal (2) two millimetres from
the outer edge of the glass, after
removing the protective sheet (3).
15
into
the
unit.
Advertisement
Table of Contents
