Table of Contents
Advertisement
EN
III.3.a INSTALLATION OF THE INDUCTION HOB
To leave the necessary space for the air pipe, it is important to install the induction hob with the
centre line more than 300mm away from any wall on the rear.
The induction hob can be installed in two ways either resting on the work surface or flush with the
work surface.
To perform LAY-ON INSTALLATION, drill the top as shown:
Fig. 3.3.a.1-A -> 60cm hob.
Fig. 3.3.a.1-A
To perform FLUSH INSTALLATION, drill and mill the work surface along the edge of the installation
hole, respecting the measurements indicated:
Fig. 3.3.a.2-A -> 60cm hob.
Fig. 3.3.a.2-A
Fig. 3.3.a.1-B -> 80cm hob.
Fig. 3.3.a.1–B
Fig. 3.3.a.2-B -> 80cm hob.
Fig. 3.3.a.2-B
14
Advertisement
Table of Contents
