Table of Contents
Advertisement
EN
III.3.d ASSEMBLING THE AIR VENTING PIPE
To bring the air outlet to the desired position, it will be necessary to install the pipe using fittings
that can be purchased separately (Fig. 3.3.d.1).
To purchase these accessories, ask the manufacturer for them.
The entire pipe must necessarily pass under the base of the unit, in the space of the plinth riser.
Our accessories also allow the installation of filtering kits.
III.4 ELECTRICAL CONNECTION
The electrical connection must ONLY be performed by specialist technicians.
The electrical protection of the electrical connection upstream of the appliance must comply with
the standards in force.
Attention! Make sure that the voltage (V) and frequency (Hz) indicated on the serial
number plate inside the appliances correspond to those available in the place of
installation.
Any modifications that may be necessary to the electrical system to install the appliance must only
be performed by competent persons.
After installation, the insulated parts and those carrying electric current must be protected from
possible contact.
Attention! If the electrical connection is performed incorrectly or not according to
the standards, parts of the appliance can be damaged and the warranty will be
invalidated.
Attention! Before any intervention, disconnect the appliance from the mains (Fig.2.1-
Fig. 2.2 WARNINGS chapter).
Fig. 3.3.d.1
20
Advertisement
Table of Contents
