Table of Contents
Advertisement
EN
Fig. 4.3.c.1
-> Each key press will be confirmed by an acoustic signal (beep).
-> Release the || key (pause) that pulsed.
-> The user menu is active.
-> The rear left cooking zone display (2RL) flashes "U0" ("U" and "0").
-> Select the menu item to be viewed/modified using the slider (4) as summarised in the table Fig.
4.3.c.2.
For example, to go to U4 (display brightness), press 2RL on the display and select level 4 with the
touch slider (the third slider bar starting from the left)
Now therefore U4 flashes intermittently.
-> At this point the left front display (2FL) is selected where the set value and any variation
possibilities are displayed.
In the example of the brightness setting, after having selected the left front display (2FL), all the
bars up to 9 will appear on the slider and the number will appear on the display (2FL) with a
permitted value, in this case from 0 to 9 (in other cases there may be fewer values, for example in
U3 there are only values from 0 to 3)
Then the selected value of the corresponding selected element is shown on the display of the front
left cooking zone (2FL), after which change the value by touching the slider.
29
Advertisement
Table of Contents
