Table of Contents
Advertisement
EN
III.3.b CONSTRUCTION INSTRUCTIONS - OUTLET ON PLINTH
To convey the air into the plinth it is necessary to create a vertical pipe parallel to the back of the
unit. Suitable size pipes and fittings are available. To purchase these accessories, ask the
manufacturer for them.
In order to correctly make the coupling between
the fitting Fig. 3.3.1-5 and the pipe, it is necessary
to cut the fitting as shown in Fig. 3.3.b.1.
To allow the vent pipe to be seated correctly, if it is provided under the plinth of the unit, the outlet
should be created in the base as shown in Fig. 3.3.b.2 and the rear panel possibly removed.
The introduction of this extraction system on a unit with a depth of 600mm implies a maximum
possible length for any drawers provided under the hob of approximately 450mm. If the depth of
the unit is greater, the underlying drawers will also have a wider length.
Fig. 3.3.b.2
18
Fig. 3.3.b.1
Advertisement
Table of Contents
