Table of Contents
Advertisement
EN
III.3.c CONSTRUCTION INSTRUCTIONS - REAR DISCHARGE
To convey the air to the rear, it is necessary to create a horizontal pipe perpendicular to the back
of the unit. Suitable size pipes and fittings are available. To purchase these accessories, ask the
manufacturer for them.
In order to correctly make the coupling between
the fitting Fig. 3.3.1-5 and the pipe, it is necessary
to cut the fitting as shown in Fig. 3.3.c.1.
To allow air to be vented to the rear, the outlet should not be created on the base of the unit.
The outlet should be created through the rear panel as indicated in Fig. 3.3.c.2 or the latter possibly
removed.
On a unit with a depth of 600 mm, the maximum possible length for any drawers provided under
the hob is approximately 550 mm. If the depth of the unit is greater the underlying drawers will
also have a wider length.
Fig. 3.3.c.2
19
Fig. 3.3.c.1
Advertisement
Table of Contents
