Table of Contents
Advertisement
EN
U3
Volume for signal
tones
U4
Display brightness
U5
Timer animation
U6
Permanent pot
detection
U7
Behaviour when the
Timer expires
IV.3.d HOB OPERATION
Before selecting any function, it is necessary to activate the desired zone.
Switch-on/off
The extractor hob is turned on by touching the ON/OFF key (1) for a few seconds.
The symbol will light up
By keeping this key pressed, all the available functions will become visible for a few moments, then
only the main functions will remain active.
While using the hob, the other functions will also be activated and can be used.
All the available functions will be illuminated with low intensity, which will only increase when they
are activated.
To switch off, touch the ON/OFF key (1) for a few seconds.
Important: This function has priority over all the others, therefore it is possible to switch off the
hob at any time.
The hob switches off automatically after 20 seconds if all the cooking levels are set to 0 and no
operation is in progress.
Selection of cooking zones
Touch the Selection/Display area (2) corresponding to the desired cooking zone.
0,1,2,3
Adjusting the volume of the acoustic signals
(e.g. when the timer expires):
0: No button tone
1: minimum volume
2: half volume
3: maximum volume
0,1,2,3,4,5,6,7,8,9 Display brightness adjustment:
0: maximum brightness
....
9: minimum brightness
0,1
0: No timer animation
1: The timer is animated 10 minutes before
it expires
Cannot be deactivated
0,1,2
0: Acoustic signal for 120 sec.
1: Acoustic signal for 10 sec.
2: No tone
31
Advertisement
Table of Contents
