Table of Contents
Advertisement
Find Quality Products Online at:
The minimum value is defined internally. The maximum value is limited to
the adjustable maximum pump power in the menu <Setpoint limits>.
4. Activate the desired pump mode.
The pump is set.
To achieve low setpoint temperatures, it may be helpful to reduce the pump
output in certain situations. This decreases the pump's heat input into the bath
fluid.
8.7
Remote control device
The device can be connected to a PC via its interfaces and controlled remotely
using a program such as ° EasyTemp. It is also possible to send interface
commands to the device using a terminal.
The respective interface is set up when the remote control is deactivated.
If remote control mode is enabled, the device cannot be operated directly.
8.7.1 Remote control device using USB interface
The device can be remote-controlled via the standard USB B interface.
The device is switched off.
The computer has a terminal program installed.
1. Connect the device (USB plug type B) to the computer with a commercially
available USB cable.
2. Download the suitable USB driver from the download area of the website
Depending on the operating system used by the connected computer, it may
be necessary to install the USB driver.
3. Install the USB driver on the computer.
4. Switch the device on.
5. Call up the <Main menu> on the device.
6. In the submenu <Connect unit>/<Remote control> activate the USB
interface.
The home screen will show USB mode.
7. Start the terminal program on the computer.
8. Use the terminal program to select the COM port of the device and establish
a connection.
Remote control via the USB interface is activated. This is shown with the
"USB" on the home screen. You can now remotely control the device with
interface commands via the computer.
GlobalTestSupply
www.
Operation
65
.com
sales@GlobalTestSupply.com
Advertisement
Table of Contents
