Table of Contents
Advertisement
5.
Check for proper tracking, and adjust the rod
as necessary.
Note:
If you are unable to achieve proper
tracking by adjusting the left control rod, contact
your Authorized Service Dealer.
6.
Check that the machine does not creep from
the neutral position with the parking brake
disengaged.
7.
Install the fuel tank, if you removed it.
8.
Install the cushion.
Checking the Tire Pressure
Service Interval: Every 50 hours/Monthly (whichever
comes first)
Maintain the air pressure in the rear tires at 83 to 97
kPa (12 to 14 psi).
Important:
Uneven tire pressure can cause an
uneven cut.
Note:
The front tires are semi-pneumatic tires and do
not require air-pressure maintenance.
Figure 59
Adjusting the Caster-Pivot
Bearing
Service Interval: Every 500 hours/Yearly (whichever
1.
Disengage the blade-control switch (PTO), move
the motion control levers to the N
position, and set the parking brake.
2.
Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
3.
Remove the dust cap from the caster and tighten
the locknut
4.
Tighten the locknut until the spring washers are
flat, and then back off a 1/4 turn to properly set
the preload on the bearings
Important:
washers are installed correctly as shown in
Figure
60.
5.
Install the dust cap
g001055
1. Spring washers
2. Locknut
42
comes first)
EUTRAL
(Figure
60).
(Figure
Make sure that the spring
(Figure
60).
Figure 60
3. Dust cap
-
LOCK
60).
g001297
Advertisement
Table of Contents
