Starting The Engine; Shutting Off The Engine - Toro GrandStand Multi Force 72524 Operator's Manual

Mower with 52in or 60in turbo force cutting unit and low flow hydraulics
Hide thumbs Also See for GrandStand Multi Force 72524:
Table of Contents

Advertisement

Starting the Engine

Important:
Do not engage the starter for more
than 5 seconds at a time. If the engine fails to
start, wait 15 seconds between attempts. Failure
to follow these instructions can burn out the
starter motor.
Note:
You may need to repeat the cycle for starting
the engine when you start it for the first time after you
have filled a completely empty fuel system with fuel.
Important:
The machine may have difficulty
starting under severe cold conditions. When
starting a cold machine, keep the machine above
-23°C (-10°F).
If the machine is not stored at the proper
temperature,
Figure 16

Shutting Off the Engine

CAUTION
Children or bystanders may be injured if they
move or attempt to operate the machine while
it is unattended.
Always remove the key and engage the
parking brake when leaving the machine
unattended.
Let the engine idle at slow throttle (turtle) for 60
seconds before turning the key switch to the O
position.
Important:
Starting and shutting off the engine
frequently in cold conditions can damage the
engine. Allow the machine to reach normal
operating temperature before shutting off the
engine.
g306776
Important:
Make sure that the fuel-shutoff valve
is closed before transporting or storing the
machine to prevent a fuel leak. Before storing the
machine, disconnect the spark plug(s) to prevent
the possibility of accidental starting.
17
Figure 17
FF
g301288

Advertisement

Table of Contents
loading

This manual is also suitable for:

Grandstand multi force 72530414932857414800000

Table of Contents