Table of Contents
Advertisement
Storage
Storage Safety
•
Shut off the engine, remove the key, and wait for
all moving parts to stop leaving the operator's
position. Allow the machine to cool before
servicing, adjusting, fueling, or storing it.
•
Let the engine cool before storing the machine.
•
Do not store the machine or fuel near flames or
drain the fuel indoors.
Cleaning and Storage
Service Interval: Before storage
Before storage
Store the machine in temperatures above -12°C
(10°F).
1.
Disengage the power takeoff (PTO), engage the
parking brake, shut off the engine, and remove
the key.
2.
Remove grass clippings, dirt, and grime from the
external parts of the entire machine, especially
the engine.
Important:
You can wash the machine
with a mild detergent and water. Do not
pressure-wash the machine. Avoid excessive
use of water, especially near the drive system
and engine. Pressure-washing can force dirt
and water into critical parts, such as spindle
bearings and electrical switches.
3.
Clean any dirt and chaff from the outside of the
engine cylinder-head fins and blower housing.
4.
Check the brake; refer to
(page
46).
5.
Service the air cleaner; refer to
Cleaner (page
31).
6.
Grease the machine; refer to
28).
7.
Change the engine oil; refer to
Engine Oil (page
8.
Check the tire pressure; refer to
Tire Pressure (page
9.
For long-term storage, do the following:
A.
Add fuel stabilizer/conditioner to the fuel in
the tank as directed by the fuel stabilizer
manufacturer.
B.
Run the engine to distribute the conditioned
fuel through the fuel system for 5 minutes.
Brake Maintenance
Servicing the Air
Lubrication (page
Servicing the
33).
Checking the
42).
C.
Shut off the engine, allow it to cool, and
drain the fuel tank; refer to
Fuel Tank (page
until it shuts off.
D.
Start the engine and allow it to run until it
shuts off. Repeat with the choke engaged (if
applicable) until the engine does not start.
E.
Dispose of fuel properly; recycle it according
to local regulations.
Important:
stabilizer/conditioner longer than
the duration recommended by the
fuel-stabilizer manufacturer.
10.
Remove the spark plug(s) and check its
condition; refer to
(page
36).
11.
With the spark plug(s) removed from the engine,
pour 15 ml (2 tablespoons) of engine oil into the
spark-plug hole, and use the starter to crank the
engine and distribute the oil inside the cylinder.
12.
Install the spark plug(s) but do not connect the
wire to the spark plug(s).
13.
Check and tighten all fasteners. Repair or
replace any part that is damaged or missing.
14.
Paint all scratched or bare metal surfaces with
paint from an Authorized Service Dealer.
15.
Store the machine in a clean, dry, garage or
storage area. Remove the key from the switch
and store it in a memorable place. Cover the
machine to protect it and keep it clean.
60
Draining the
37), or operate the engine
Do not store fuel containing
Removing the Spark Plug
Advertisement
Table of Contents
