Toro GrandStand Multi Force 72524 Operator's Manual page 34

Changing the Engine Oil
Service Interval: After the first 8 hours
Every 100 hours
Note:
Dispose of the used oil at a recycling center.
1. Park the machine so that the drain side is slightly
lower than the opposite side to assure the oil
drains completely.
2. Disengage the PTO, move the motion-control
levers to the N
EUTRAL
engage the parking brake.
3. Shut off the engine, remove the key, and wait
for all moving parts to stop before leaving the
operating position.
4. Change the engine oil as shown in
- position, and
LOCK
Figure 45.
5. Slowly pour approximately 80% of the specified
oil into the filler tube and slowly add the
additional oil to bring it to the Full mark
46).
34
Figure 45
g032710
g027734
(Figure