Toro GrandStand Multi Force 72524 Operator's Manual page 32

Figure 41
1. Air-inlet cover
2. Air-inlet screen
6. Release the latches on the air cleaner and pull
the air-cleaner cover off the air-cleaner body
(Figure 42).
7. Clean the inside of the air-cleaner cover with
compressed air.
8. Gently slide the primary filter out of the
air-cleaner body (Figure
Note:
Avoid knocking the filter into the side of
the body.
9. Remove the inner filter only if you intend to
replace it.
Figure 42
1. Inner filter
2. Primary filter
3. Air-cleaner cover
g012996
3. Air-cleaner body
4. Latch
42).
g012997
4. Latch
5. Air-cleaner body
Inspecting the Filters
1. Inspect the safety filter. If it is dirty, replace both
the safety and primary filters.
Important:
Do not attempt to clean the
safety filter. If the safety filter is dirty, then
the primary filter is damaged.
2. Inspect the primary filter for damage by looking
into the filter while shining a bright light on the
outside of the filter. If the primary filter is dirty,
bent, or damaged, replace it.
Note:
Holes in the filter appear as bright spots.
Do not clean the primary filter.
Installing the Filters
Important:
To prevent engine damage, always
operate the engine with both air filters and the
cover installed.
1. If you are installing new filters, check each filter
for shipping damage.
Note:
Do not use a damaged filter.
2. If you are replacing the inner filter, carefully slide
it into the filter body
3. Carefully slide the primary filter over the safety
filter (Figure 42).
Note:
Ensure that the primary filter is fully
seated by pushing on the outer rim while
installing it.
Important:
Do not press on the soft, inside
area of the filter.
4. Install the air-cleaner cover and secure the
latches (Figure
32
(Figure 42).
42).